Table of Contents
Advertisement
Calling up options
● Switch the ignition on.
● If a message or vehicle symbol is displayed, press
(⇒ F ig. 29
).
A
● Press the top or bottom part of the rocker switch
tion appears.
Multifunction display (MFI)
The multifunction display (MFI) has two automatic memories: 1 - Partial
memory and 2 - Total memory. The selected memory will be shown in the
lower right-hand corner of the display.
With the ignition switched on, and memory 1 or 2 displayed, briefly press
to change from one memory to another.
OK
The memory stores the values for the journey and the con-
sumption from the moment the ignition is switched on un-
Trip memo-
til it is switched off again.
ry (for a
1
If the journey is broken for more than 2 hours, the memory
single jour-
is automatically erased. If the journey is continued in less
ney).
than 2 hours after the ignition is switched off, the new da-
ta is added to the data already stored in the memory.
The memory stores the values of any number of journeys,
until it counts a total of 19 hours and 59 minutes of driv-
Total mem-
ing, or 1999.9 km or miles of driving, depending on the
2
ory (for all
type of instrument panel fitted. On reaching either of these
journeys).
limits, the memory is automatically erased and starts to
count from 0 again.
Safety
OK/RESET
until the desired op-
B
Operation
Possible displays
Menu
Function
Time
Current time in hours (h) and minutes (min).
Journey duration
This indicates the hours (h) and minutes (min)
since the ignition was switched on.
The current fuel consumption display operates
Current fuel consump-
tion
throughout the journey, in litres/100 km; and with
the engine running and the vehicle stopped, in li-
tres/hour.
After turning on the ignition, average fuel con-
Average fuel consump-
tion
sumption in litres/100 km will be shown after trav-
elling about 100 metres. Otherwise horizontal lines
are displayed. The value shown is updated approxi-
mately every 5 seconds.
Operating range
Approximate distance in km that can still be travel-
led with the fuel remaining in the tank, assuming
the same style of driving is maintained. This is cal-
culated using the current fuel consumption.
Distance covered
Distance travelled, after ignition is switched on, in
km.
The average speed will be shown after a distance of
Average speed
about 100 metres has been travelled. Otherwise
horizontal lines are displayed. The value shown is
updated approximately every 5 seconds.
Current speed displayed digitally.
Digital display of
speed
Liquid coolant temper-
Digital display of the current temperature of the en-
ature digital display
gine liquid coolant.
Warning at --- km/h
If the stored speed is exceeded (between 30 -
250 km/h, or 18 - 155 mph), an audible warning is
given together with a visual warning.
Changing between display modes
● Press the rocker switch in the windscreen wiper lever.
Advice
Cockpit
Technical specifications
49
Advertisement
Table of Contents
