Table of Contents
Advertisement
Turn signal and main beam lever
Move the lever to the required position:
Right turn signal.
1
Left turn signal.
2
Switching on main beam ⇒
3
the warning lamp lights up on the instrument panel.
Switch on the flasher or switch off the main beam headlights. The flash-
4
ed beam comes on if the lever is pressed. The warning lamp will
light up during this process.
Push the lever all the way down to turn off the corresponding function.
Convenience turn signals
For the convenience turn signals, move the lever as far as possible upwards
or downwards and release the lever. The turn signal will flash 3 times.
The convenience indicators can be deactivated at a Specialised workshop.
WARNING
Incorrect use of the headlights may cause accidents and serious injury,
as the main beam may distract or dazzle other drivers.
Safety
Fig. 46 Turn signal and
main beam lever in their
initial position
. When the main beam is switched on,
Operation
Note
● The turn signal only works when the ignition is switched on. The hazard
warning lights also work when the ignition is switched off ⇒ p age 207.
● If any of both turn signals fails, the warning lamp will start flashing twice
faster than normal.
● The main beam headlights can only be switched on if the dipped beam
headlights are already on.
Turning on and off lights
The legal requirements regarding the use of vehicle lights in each country
must be observed.
Advice
Lights and visibility
Fig. 47 Next to the
steering wheel: diagram
of some of the types of
light switch
Technical specifications
67
Advertisement
Table of Contents
