Table of Contents
Advertisement
Control lamp on the vehicle key
When a button on the vehicle key is pressed, the control lamp flashes
⇒ F ig. 32
(arrow) once briefly. If the button is pressed and held, the indica-
tor blinks several times, for example: for the convenience opening function.
When the control lamp does not light when the button is pressed, the bat-
teries of the vehicle key must be changed ⇒ p age 53.
Changing the battery
Safety
Fig. 32 Control lamp on
the vehicle key
Fig. 33 Vehicle key: bat-
tery compartment cover
Operation
SEAT recommend having the batteries changed in a specialised workshop.
The battery is located to the rear of the vehicle key, under a cover.
Changing the battery
● Unfold the vehicle key shaft ⇒ p age 51.
● Remove the cover from the back of the vehicle key
tion of the arrow ⇒ .
● Extract the battery from the compartment using a suitable thin object
⇒ F ig.
34.
● Place the new battery in the compartment, pressing in the direction of
⇒ F ig. 34
⇒ .
the arrow as shown
● Fit the battery compartment cover, pressing in the direction of the arrow
⇒ F ig. 33
as shown
until it clicks into place.
CAUTION
● If the battery is not changed correctly, the vehicle key may be damaged.
● Use of unsuitable batteries may damage the vehicle key. For this reason,
always replace the dead battery with another of the same voltage, size and
specifications.
● When fitting the battery, check that the polarity is correct.
Advice
Opening and closing
Fig. 34 Vehicle key: re-
moving the battery
⇒ F ig. 33
in the direc-
Technical specifications
53
Advertisement
Table of Contents
