Table of Contents
Advertisement
Changing the side turn signal bulb
Complete operations only in the sequence given:
1.
With one hand move the side turn signal backwards
2.
Remove the side turn signal from the chassis by leverage
Remove the bulb holder with the bulb in the direction of the arrow
3.
⇒ F ig. 154
.
1
4.
Remove the bulb holder bulb in a straight direction.
5.
Replace the faulty bulb by a new identical bulb.
Safety
Fig. 153 Removing the
side turn signal
Fig. 154 Side turn sig-
nal: changing the bulbs.
⇒ F ig. 153
1
.
2
Operation
Complete operations only in the sequence given:
6.
Install the lamp holder.
Place the side turn signal on the chassis on the side situated to-
7.
wards the rear of the vehicle until the spring clicks into the other
side of the side turn signal.
Starting assistance
Introduction
If the engine fails to start because of a discharged battery, the battery of an-
other vehicle can be used to start the engine. Before starting, check the
magic eye on the battery ⇒ p age 181.
For starting assistance, jump lead cables conforming to the standard
DIN 72553 are required (see the cable manufacturer instructions). The cable
section in vehicles with petrol engine must be at least 25 mm
WARNING
Incorrect use of jump leads and incorrectly jump starting could cause the
battery to explode resulting in serious injury. Please observe the follow-
ing rules to minimise the risk of a battery explosion:
● The battery providing current must have the same voltage (12V) and
.
approximately the same capacity (see markings on battery) as the flat
battery.
● Never charge a frozen or recently thawed battery. A flat battery can al-
so freeze at temperatures close to 0 °C (+32 °F).
● If a battery is frozen and/or has been frozen then it must be replaced.
Advice
If and when
2
.
Technical specifications
221
Advertisement
Table of Contents
