Table of Contents
Advertisement
216
If and when
WARNING (Continued)
● The bulbs H4, HB4 and H7 are pressurised and might explode on
changing them.
● Only replace the bulbs concerned when they have cooled.
● Never replace bulbs alone if you are not familiar with the operations
necessary. If you are not sure about procedures then visit a specialised
workshop to carry out the necessary work.
● Never touch the bulb glass directly. Fingerprints will be evaporated by
the heat of the operating bulb thus "fogging" up the reflector.
● The headlamp frameworks in the engine compartment and the tail
lamps contain sharp elements. Always protect your hands when chang-
ing bulbs.
CAUTION
● After changing a bulb, if the rubber covers are not replaced correctly on
the headlamp framework, the electrical installation may be damaged, espe-
cially if water is allowed to enter.
● Remove the ignition key before working on the electric system. Other-
wise, a short circuit could occur.
● Switch off the lights and the parking light before changing a bulb.
● Take good care to avoid damaging any components.
Replacing the bulbs in the headlights
There is no need to remove the headlight to replace bulbs.
Fig. 146 In the engine
compartment: rear view
of the front left headlamp
with rubber cover:
A
dipped beam and main
beam headlights,
side
B
lights and daytime driv-
ing lights and
turn
C
signal
Advertisement
Table of Contents
