Seat Mii 2014 Owner's Manual page 181

Table of Contents

Advertisement

It
lights
Possible cause
up
Excessive engine coolant
temperature.
Insufficient engine cool-
ant level.
Engine coolant system
faulty.
Flash-
Possible cause
es
Engine coolant system
faulty.
WARNING
Observe the safety warnings ⇒ 
page 48.
Note
On the display of the Portable Navigation System (supplied by SEAT)
⇒  p age 160 an engine coolant temperature gauge can be seen.
Engine coolant specifications
The engine cooling system is supplied from the factory with a specially trea-
ted mixture of water and, at least, 40 % of the additive G 13 (TLVW 774 J).
Safety
Solution
 Stop the vehicle!
Stop the vehicle safely as soon as pos-
sible. Switch off the engine and let it
cool.
 ¡Stop the vehicle!
Check the engine coolant when the en-
gine has cooled and, if it is low, refill
with engine coolant ⇒  p age 180.
 Do not drive any further.
Obtain professional assistance.
Solution
Seek specialist assistance.
in Control and warning lamps on
Operation
The engine coolant additive is recognisable by its purple colour. This mix-
ture of water and additive gives the necessary frost protection down to
-25 °C (-13 °F) and protects the light alloy parts of the cooling system
against corrosion. It also prevents scaling and considerably raises the boil-
ing point of the coolant.
To protect the engine cooling system, the percentage of additive must al-
ways be at least 40 %, even in warm climates where anti-freeze protection is
not required.
If greater frost protection is required in very cold climates, the proportion of
additive can be increased. However, the percentage of additive should not
exceed 60%, as this would reduce frost protection and, in turn, decrease
cooling capacity.
When the coolant is topped up, use a mixture of distilled water and, at
least, 40 % of the G 13 or G 12 plus-plus (TL-VW 774 G) additive (both are
purple) to obtain an optimum anticorrosion protection ⇒  . The mixture of
G 13 with G 12 plus (TL-VW 774 F), G 12 (red) or G 11 (green-blue) engine
coolants will significantly reduce the anticorrosion protection and should,
therefore be avoided ⇒  .
WARNING
If there is not enough anti-freeze in the coolant system, the engine may
fail leading to serious damage.
● Please make sure that the percentage of additive is correct with re-
spect to the lowest expected ambient temperature in the region in which
the vehicle is to be used.
● When the outside temperature is very low, the coolant could freeze
and the vehicle would be immobilised. In this case, the heating would
not work either and inadequately dressed passengers could die of cold.
Advice
Checking and refilling levels
Technical specifications
179

Advertisement

Table of Contents
loading

Table of Contents