Table of Contents
Advertisement
220
If and when
To change the bulb
Unlock the bulb holder locking tab (arrow)
8.
the bulb holder from the tail light.
9.
Replace the faulty bulb by a new identical bulb
Place the lamp holder in the tail light unit. The attachment tabs (ar-
10.
row) should audibly click into place
Assembling the tail light units
11. Carefully insert the tail light unit into the opening in the bodywork.
Support the tail light with one hand in the assembly position and
12.
securely screw the wing nut with the other
Ensure that the tail light unit has been correctly fitted and is firmly
13.
secured.
Insert the connector
14.
on the connector in the opposite direction to the arrow
B.
15. Insert the cover. The cover should lock into place.
16. Close the rear lid ⇒ p age 59.
Changing the number plate light
⇒ F ig. 150
C and remove
⇒ F ig. 150
⇒ F ig. 150
C.
⇒ F ig. 149
5
into the bulb holder and press the lock
2
⇒ F ig. 149
Fig. 151 On the rear
bumper: remove the
number plate light.
D.
B.
Complete operations only in the sequence given:
With one hand, press on the number plate light from left to right
1.
and remove it from the bumper
3
2.
Detach the number plate light carefully from the bumper.
Turn the bulb holder with the bulb anticlockwise and remove it in
3.
the direction of the arrow
4.
Replace the faulty bulb by a new identical bulb.
Place the bulb holder in the number plate light and press in the op-
5.
posite direction to the arrow as far as possible
Insert the number plate light carefully into the left edge of the open-
ing on the bumper. During this process, check that the assembly di-
6.
rection of the number plate light is correct, i.e. the spring must be
on the right.
Insert the number plate light into the bumper until it audibly clicks
7.
into place.
Fig. 152 Number plate
light: remove the bulb
holder.
⇒ F ig.
151.
⇒ F ig.
152.
⇒ F ig.
152.
Advertisement
Table of Contents
