AEG BSE782320B User Manual page 50

50 www.aeg.com
Problem
The lamp does not operate.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The descaling procedure is
interrupted before it finishes.
The descaling procedure is
interrupted before it finishes.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The cleaning function is in-
terrupted before it finishes.
The cleaning function is in-
terrupted before it finishes.
There is too much water on
the bottom of the cavity af-
ter the end of the cleaning
function.
There is no good perform-
ance of the cleaning proce-
dure.
Possible cause
The lamp is defective.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
There is an electrical fault.
You left the dish in the oven
for too long.
There was a power cut.
The function was stopped by
the user.
You did not fill the water
drawer to the maximum lev-
el.
The grill- / roasting pan is on
a wrong shelf position.
There was a power cut.
The function was stopped by
the user.
You sprayed too much de-
tergent in the appliance be-
fore the activation of the
cleaning cycle.
The initial oven cavity tem-
perature of the steam clean-
ing function was too high.
Remedy
Replace the lamp.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
• Turn off the oven with the
house fuse or the safety
switch in the fuse box
and turn it on again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roasting
pan on the first shelf posi-
tion.
Repeat the procedure.
Repeat the procedure.
Cover all parts of the cavity
with a thin layer of the deter-
gent. Spray the detergent
evenly.
Repeat the cycle. Run the cy-
cle when the appliance is
cold.