5. BEFORE FIRST USE
Refer to Safety chapters.
5.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the oven.
Refer to "Care and
Clean the oven and the accessories
before first use.
Put the accessories and the removable
shelf supports back to their initial
5.2 First Connection
When you connect the oven to the mains
or after the power cut, you have to set
When the water hardness exceeds the
values in the table, fill the water drawer
with bottled water.
1. Take the 4 colour change strip
supplied with the steam set in the
2. Put all the reaction zones of the strip
into the water for approximately 1
Do not put the strip into the running
Heat + Hold
0 - 7
0 - 1.3
7 - 14
1.3 - 2.5
14 - 21
2.5 - 3.8
The function is on.
the language, the display contrast, the
display brightness and the time of the
5.3 Setting the water hardness
The table below shows the water
hardness range (dH) with the
corresponding Calcium deposit and the
quality of the water.
0 - 50
50 - 100
100 - 150
3. Shake the strip to remove the excess
of the water.
4. Wait 1 minute and check the water
hardness with the table below.
The colours of the reaction zones
continue to change. Do not check
the water hardness later than 1
minute after test.
5. Set the water hardness: menu: Basic
to set the value.