Customizing The Pv/Sp Display; Pv/Sp Display Selections - Omron E5CC User Manual

4-13 Customizing the PV/SP Display

The following table shows the contents of the No. 1, 2, and 3 displays, according to the setting of the
PV/SP Display Screen Selection parameter.

4-13-1 PV/SP Display Selections

The following table shows the contents of the No. 1, 2, and 3 displays, according to the setting of the
PV/SP Display Screen Selection parameter in the Advanced Function Setting Level.
Set value
0
1
2
3
4
5
6
7
8
* The set value of the Alarm Value 1 parameter is displayed even if it is not valid due to the setting of the
Alarm 1 Type parameter.
PV
SP
During temperature input, the decimal point position depends on the currently selected sensor, and dur-
ing analog input it depends on the Decimal Point parameter setting.
PV/SP Display Selections
Code
spd1
spd2
* The default is 1 for models other than the E5@C-@-0@.
MV Displays for Heating and Cooling Control (Not Supported for
Position-proportional Models.)
Select either the manipulated variable for heating or the manipulated variable for cooling as the MV
to be displayed for PV/SP/MV during heating and cooling control. The MV Display Selection
parameter is displayed only when heating/cooling control is being performed and PV/SP/MV is
selected in the PV/SP Display Screen parameter or a Monitor/Setting Item Display parameter.
E5@C Digital Temperature Controllers User's Manual (H174)
No. 1 display
Nothing is displayed. Nothing is displayed.
PV SP
PV Nothing is displayed.
SP SP (character display)
PV SP
PV SP
PV SP
PV SP
PV SP
Temperature input: The specified range for the specified sensor.
Analog input: Scaling lower limit −5%FS to Scaling upper limit +5%FS
Setting (monitoring) range
SP lower limit to SP upper limit
Parameter
PV/SP No. 1 Display Selection
PV/SP No. 2 Display Selection
No. 2 display No. 3 display (E5EC/E5AC only)
Nothing is displayed.
Nothing is displayed.
Nothing is displayed.
Nothing is displayed.
MV
(Valve opening for Position-proportional
Models)
Multi-SP No.
Soak Time Remain
Internal Set Point (ramp SP)
Alarm Value 1*
Monitoring range
Default
4*
0
4 Basic Operation
000
Unit
EU
Unit
EU
Level
Advanced Function Setting
Level
4 - 49
4