Omron E5CC User Manual page 227

hys
chys
This parameter sets the hysteresis for ensuring stable operation at the ON/OFF switching point.
• For standard control, use the Hysteresis (Heating) parameter. The Hysteresis (Cooling)
parameter cannot be used.
• For heating/cooling control, the hysteresis can be set independently for heating/cooling.
Function
The Hysteresis (Heating) parameter is used for the heating side, and the Hysteresis
(Cooling) parameter is used for the cooling side.
Parameter name
Hysteresis
Setting
(Heating)
Hysteresis
(Cooling)
Related Parameters
See
See
PID ON/OFF (Initial Setting Level): Page 6-44
Standard or Heating/Cooling (Initial Setting Level): Page 6-45
soak
• This parameter sets the time for the control operation when using the simple program
function.
Function
Setting
Related Parameters
See
See
Program Start (Operation Level): Page 6-12
Soak Time Remain (Operation Level): Page 6-13
Wait Band (Adjustment Level): Page 6-32
Program Pattern (Initial Setting Level): Page 6-46
Soak Time Unit (Advanced Function Setting Level): Page 6-80
E5@C Digital Temperature Controllers User's Manual (H174)
Hysteresis (Heating)
Hysteresis (Cooling)
Temperature input
Analog input
Temperature input
Analog input
000
Soak Time
Setting range
1 to 9999
The control must be ON/OFF control.
For the Hysteresis (Cooling) parameter, the control
must be heating/cooling control.
Setting range
0.1 to 999.9
0.01 to 99.99
0.1 to 999.9
0.01 to 99.99
The Program Pattern parameter must not be set to
OFF.
Unit Unit
min or h
6 Parameters
Unit Default
°C or °F
1.0
%FS 0.10
°C or °F
1.0
%FS 0.10
1
6
6 - 31