Navigate A Saved Itrack; Stop Recording; Navigate A Saved Itrack On The Chart View - Humminbird i-PILOT LINK Operation Manual

Stop Recording

1. Press the MARK key.
2. Select Stop Recording iTrack. Press the RIGHT Cursor key.
3. Follow the on-screen prompts to save or discard the iTrack.

Navigate a Saved iTrack

If a saved iTrack is within 1/4 mile of the boat position, you can start navigation towards it. iTrack navigation will start towards the
nearest point on the iTrack, and then it will navigate to the Start Point or End Point, depending on your selection.
You can select a saved iTrack on the Chart View or the Go To menu. You can also start navigation to a saved iTrack from the Waypoint
Management dialog box (see Manage your i-Pilot Navigation Data).
If you start another mode of i-Pilot Link navigation, iTrack navigation will disengage automatically. The exception is Spot-Lock,
which will pause the iTrack navigation.
Networked Control Heads: To share an iTrack on the network or change the iTrack position, you must start navigating the iTrack on
the control head you used to record it.

Navigate a Saved iTrack on the Chart View

1. Use the Cursor Control key to select a Start Point icon, an End Point icon, or a position on the iTrack.
2. Press the GO TO key.
3. Select one of the following, and press the RIGHT Cursor key.
To start navigation to the iTrack Start Point, select Navigate to Start.
To start navigation to the iTrack End Point, select Navigate to End.
To navigate to a point within the iTrack, select Go To Position. When you select Go To Position, the i-Pilot Link will navigate to
the cursor position, but it wil not start navigation on the iTrack.
CAUTION! Be prepared for boat movement as the prop will automatically be enabled and the prop speed will automatically adjust
to move the boat to the iTrack position. If the boat does not move, confirm the prop is turned on in the menu system (see
Propeller Controls).