Back End Board And Hard Drive/Ide Board Installation - Polaroid PDC2000 Repair Manual

PDC 2000/3000 Repair Manual
Back End Board
Power Button
Board
Hard Drive
(PDC2000 Only)
IDE Board
(PDC3000 Only)
Figure 5- 8. Removing back end board and hard drive/IDE board
PDC2000 Only
5. • Lift the back end board with attached hard drive out of the camera chassis.
• Separate the hard drive assembly from the back end board by gently prying the two
apart using a plastic soldering aide or similar tool.
• At this point, the hard drive may be removed from the isolation spring and retaining band.
PDC3000 Only
6. • Lift the back end board with attached IDE board out of the camera chassis.
• Disconnect the IDE board from the back end board.

Back End Board and Hard Drive/IDE board Installation

To install the back end board and hard drive/IDE board, reverse the removal procedure.
There may be a compatibility problem between the hard drive connector
and the back end board if different configuration parts are mixed. Generally,
PBO2 back end boards require PBO2 hard drive connectors and PBO3
back end boards require PBO3 hard drive connectors.
Caution
90
Parts Replacement
Front End Board
Back End Board Cable
Disconnect Back End
Board cable from
connector on Power
Supply/Strobe board