Image Performance; Required Test Equipment And Tools; Equipment Setup - Polaroid PDC2000 Repair Manual

PDC 2000/3000 Repair Manual
Image Performance Test

Required Test Equipment and Tools

• Power Computing Power PC or equivalent
• PDC2000 Switching Power Supply
• Camera SCSI Cable
• Universal Camera Test Fixture (Nest)
• Kyroitso Light Source
Equipment Setup (Figure 3-7)
1. Place the camera onto the universal camera test fixture (nest).
2. Connect the camera SCSI cable from the host computer SCSI connector to the camera
SCSI connector.
3. Connect the switching power supply cable to the camera's external power connector.
4. If applicable, set the camera's SCSI ID to 4.
5. If applicable, replace camera lens with an 11mm lens.
Note: 11mm lens is standard. Some camera's come in for repair with the
optional 17mm lens attached.
For testing purposes the standard 11mm lens must be used.
6. Turn on the test equipment as follows:
• Power Computing Power PC On/Off (0/1) switch to On (1).
• Kyroitso Light Source On/Off switch to On.
Note: Allow the Kyroitso Light Source to warm up for approximately
five (5) minutes before use.
• Turn on the camera.
34
Testing&Adjustment