Table of Contents
Advertisement
PDC 2000/3000 Repair Manual
Troubleshooting Camera Malfunctions
Once the camera malfunction is determined, perform the following:
To prevent electrostatic damage to camera components, the repair
technician must be grounded in accordance with approved grounding
procedures.
In addition, the camera must be placed on an anti-static mat.
1. Place the camera on a padded work area to prevent scratches to its exterior surfaces.
2. Remove the camera's top cover as follows: (Figure 4-1)
•
Turn the camera power off and remove the battery tray.
•
Remove the lens assembly.
•
Remove the eyecup retainer and the eyecup from the viewfinder assembly.
•
Open the rubber SCSI connector door and remove the two (2) screws from inside the
compartment.
•
Turn the camera over and remove the four (4) remaining screws that secures the top
cover to the bottom cover assembly.
Note:
Location of four (4) remaining screws:
•
Two (2) from the battery tray area.
•
Two (2) from either side of the lens housing.
•
Holding the top and bottom halves together, turn the camera right-side-up on the
padded work area.
•
Place a foam pad to the left, towards the SCSI connector end of the camera.
•
Carefully disengage the rubber edit PC board from the bottom cover while pivoting the
top cover up and to the left, towards the SCSI connector end.
•
Gently place the top cover onto the foam pad.
CAUTION
64
Diagnostics and Troubleshooting
Advertisement
Table of Contents
Troubleshooting
