Dimestore; Required Test Equipment And Tools; Equipment Setup - Polaroid PDC2000 Repair Manual

PDC 2000/3000 Repair Manual
Dime Store
Note: • This VI only runs on LabView version 3.1.
• This program is used to focus and re-pin the focus gear.

Required Test Equipment and Tools

• Power Computing Power PC or equivalent
• PDC 2000 Switching Power Supply
• Camera SCSI Cable
• Diorama Test Bench
• PDC Diorama Camera Test Fixture (Nest)
• Checker/Resolution Target
• Tweezers
• Needle Nose Pliars
Equipment Setup (Figure 3-12)
1. Place the camera onto the PDC Diorama Camera Test Fixture (Nest).
2. Flip up the checker/resolution target. Camera should be aimed at checker/resolution
target.
3. Open the camera.
4. Using tweezers or needle nose pliars, gently remove the red pin from the focus gear.
5. Manually move the focus gear to its home (start position).
6. Connect the camera SCSI cable from the host computer SCSI connector to the camera
SCSI connector.
7. Connect the switching power supply cable to the camera's external power connector.
8. If applicable, set the camera's SCSI ID to 4.
52
Testing & Adjustment