Front End Removal; Protective Tape Over Transducer Connection; Removing Front End Board - Polaroid PDC2000 Repair Manual

PDC 2000/3000 Repair Manual
Figure 5- 5. Protective tape over transducer connections
Front End Board Removal
1. Remove the top cover.
2. Remove the transducer assembly.
3. Disconnect the optics module cable from connector J1 on the front end board (Figure 5- 6).
Phillips Pan-Head Screws
4. Disconnect the optics module cable from connector J2 on the front end board.
J3
(#2-28x1/2)
Pry up here
Figure 5- 6. Removing front end board
Replace protective
tape over electrical
connections
J2
Pry up here
J1
87
Parts Replacement
Bottom Chassis
Assembly
Phillips Pan-Head Screws
(#2-28x1/2)