Configuration Procedure; Software Upgrade Example (For Irf Mode); Network Requirements - HP 10500 Series Configuration Manual

Figure 37 Network diagram
TFTP client
1.1.1.1/24
Device

Configuration procedure

# Configure IP addresses and routes to make sure the device and the TFTP server can reach each other.
(Details not shown.)
# Complete TFTP settings on both the device and the TFTP server. (Details not shown.)
# Display information about the current software images.
<Sysname> display version
# Use TFTP to download the image file 10500.ipe from the TFTP server to the root directory of the flash
on the active MPU.
<Sysname> tftp 2.2.2.2 get 10500.ipe
# (Optional.) Back up the image file to 10500-backup.ipe. Skip this step if the flash does not have
sufficient space.
<Sysname> copy 10500.ipe 10500-backup.ipe
# Specify 10500.ipe as the main startup image file for both MPUs.
<Sysname> boot-loader file flash:/10500.ipe slot 0 main
<Sysname> boot-loader file flash:/10500.ipe slot 1 main
# Specify 10500-backup.ipe as the backup startup image file for both MPUs.
<Sysname> boot-loader file flash:/10500-backup.ipe slot 0 backup
<Sysname> boot-loader file flash:/10500-backup.ipe slot 1 backup
# Verify the startup image settings.
<Sysname> display boot-loader
# Reboot the device to complete the upgrade.
<Sysname> reboot
# Verify that the device is running the correct software.
<Sysname> display version

Software upgrade example (for IRF mode)

Network requirements

Use the file 10500.ipe to upgrade software images for the IRF fabric in
Each IRF member device has two MPUs: one in slot 0 and one in slot 1. The global active MPU is in slot
0 on the master device.
2.2.2.2/24
Internet
114
TFTP server
Figure 38.