HP 10500 Series Configuration Manual page 43

Hide thumbs Also See for 10500 Series:
Table of Contents

Advertisement

Step
5.
Enter VTY line view or
class view.
6.
Enable scheme
authentication.
7.
(Optional.) Specify
the protocols for the
user lines to support.
Command
To enter VTY line view:
line vty first-number
[ last-number ]
To enter VTY line class view:
line class vty
authentication-mode scheme
In non-FIPS mode:
protocol inbound { all | ssh
| telnet }
In FIPS mode:
protocol inbound ssh
35
Remarks
Use either command.
A setting in user line view is applied only to the
user line. A setting in user line class view is
applied to all user lines of the class.
A non-default setting in either view takes
precedence over a default setting in the other
view. A non-default setting in user line view
takes precedence over a non-default setting in
user line class view.
A setting in user line view takes effect
immediately and affects the online user. A
setting in user line class view does not affect
online users and takes effect only for users who
log in after the configuration is completed.
In non-FIPS mode, password authentication is
enabled for VTY lines by default.
In FIPS mode, scheme authentication is
enabled for VTY lines by default.
In VTY line view, this command is associated
with the protocol inbound command:
If the setting of either command is not the
default in VTY line view, the setting of the
other command in VTY line view takes
effect.
If the settings of both commands are the
defaults in VTY line view, the settings of the
commands in VTY line class view take
effect.
In non-FIPS mode, both Telnet and SSH are
supported by default.
In FIPS mode, SSH is supported by default.
This configuration takes effect only for users
who log in to the user lines after the
configuration is completed.
In VTY line view, this command is associated
with the authentication-mode command:
If the setting of either command is not the
default in VTY line view, the setting of the
other command in VTY line view takes
effect.
If the settings of both commands are the
defaults in VTY line view, the settings of the
commands in VTY line class view take
effect.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents