Removing The Slot Cover; Removing The Optional Board; Mounting The Optional Board - Siemens 6SE7011-5EP60 Operating Instructions Manual

Installation
Removing the slot
cover
Removing the
optional board
Mounting the
optional board
NOTICE
5-8
www.aotewell.com
♦ Remove the cover of the selected slot on the front panel.
♦ To do so, you must carefully cut through the four connecting points
of the cover on the front panel with a thin knife.
♦ Undo the two optional board screws by about one turn each.
♦ Loosen the connection between the system connector and the
board so as to prevent any mechanical tension arising when the
screws are fully unscrewed.
♦ Take out the optional board screws and remove the board.
Optional boards can only be inserted in slot A and slot B. Slot C of the
unit is permanently pre-assigned for the terminal module EBV.
♦ Insert the optional board from the behind the broken-out slot conver
( ) until the position of the 64-pole system connector on the
electronic board corresponds with the position of the socket.
♦ Insert the option board into the 64-pole system connector on the
electronic board (
♦ Screw the optional board tight at the fastening points in the front
section of the optional board with the two screws (
Slot A
Slot B
Slot C
Fig. 5-7 Installing the optional board
sales@aotewell.com
).
Operating Instructions
Industry Automation
05.2003
).
Slot B
Slot C
6SE7087-6JP60 Siemens AG
SIMOVERT MASTERDRIVES
+86-755-8660-6182