Netbackup Appliance Software Corruption - Symantec NetBackup 5030 Troubleshooting Manual

NetBackup appliance software corruption

Steps for replacing an appliance and attached storage disk units
Table 11-6
after they have been rendered non-operational (continued)
Steps Action
Step 3 Power on the new components.
Step 4 Configure the appliance and
storage systems.
Step 5 Recover the data from a
secondary backup site.
Use the following steps as a guide to determine the type of software corruption you
are experiencing and where you can get more information on your specific scenario
Disaster recovery scenarios
Description
Power on the components in the following order:
Storage systems
■
Master server
■
Media server
■
Configure the appliance as you would a new
configuration.
See the "Initial Configuration" chapter of the
Symantec NetBackup 52xx Appliance Hardware
Installation and Initial Configuration Guide for
more information on setting up your appliance
and attached storage systems.
If you have a secondary backup site, Symantec
Technical Support will help you work through
recovering your data from a secondary backup
site.
Disaster Recovery 154