Symantec NetBackup 5030 Troubleshooting Manual page 144

Warning: NetBackup appliances do not support configuring two IP addresses that
belong to the same subnet. The appliance runs on the Linux operating system and
this type of networking is a current limitation. Each bond that you create must use
an IP address that belongs to a different subnet.
Note: You cannot remove an IP address if the appliance host name resolves to that
IP address.
Caution: Before or immediately after initial configuration, you must change the
default maintenance password (
be provided to technical support in case you need future troubleshooting assistance.
You must change the maintenance password through the NetBackup Appliance
Shell Menu with one of the following commands:
or
maintenance Main > Support > Maintenance > passwd
information, see the Symantec NetBackup Appliance Command Reference Guide.
To reconfigure a 52xx media server appliance from the USB drive using the
NetBackup Appliance Shell Menu
1 If you cannot log into the appliance, insert the USB drive into the appliance,
turn on the appliance, and then proceed to Step 4.
If you can log into the appliance and you can access theNetBackup Appliance
Shell Menu, export (copy) and move the IPsec credentials to a remote drive
using the following steps and then continue with Step 2
Open a CIFS and an NFS share with the following command:
■
Manage > Software > Share Open
To export (copy) the IPsec credentials, enter the following command:
■
Network > Security > Export <yes/no> /inst/patch/incoming
Where <yes/no> is for whether you want password protection.
Note: The output from the
the actual certificate. If you select
a number with the
password, a period precedes the file name (
If you use a password, retain the name of the password to use when you
run the
Import
) for your appliance. This password must
P@ssw0rd
command creates a backup
export
yes
extension (
.pfx nnnnnnn.pfx
command later in this procedure.
Disaster Recovery
Disaster recovery scenarios
Main > Settings > Password
. For complete
to use a password, the file name is
). If you select
).
.nnnnnnn.pfx
144
file of
.pfx
for no
no