Configuring A Management Interface On An Ethernet Port; Vlan Interfaces - Dell S4048–ON Configuration Manual

• Primary and secondary management interface IP and virtual IP must be in the same subnet.
To view the Primary RPM Management port, use the show interface Managementethernet command in EXEC Privilege
mode. If there are two RPMs, you cannot view information on that interface.

Configuring a Management Interface on an Ethernet Port

You can manage the system through any port using remote access such as Telnet.
To configure an IP address for the port, use the following commands. There is no separate management routing table, so configure
all routes in the IP routing table (the ip route command).
• Configure an IP address.
INTERFACE mode
ip address
• Enable the interface.
INTERFACE mode
no shutdown
• The interface is the management interface.
INTEFACE mode
description
Example of the show interface and show ip route Commands
To display the configuration for a given port, use the show interface command in EXEC Privilege mode, as shown in the
following example. To display the routing table, use the show ip route command in EXEC Privilege mode.
Dell#show int TenGigabitEthernet 1/1
TenGigabitEthernet 1/1 is up, line protocol is up
Description: This is the Managment Interface
Hardware is Force10Eth, address is 00:01:e8:cc:cc:ce
Current address is 00:01:e8:cc:cc:ce
Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.240/23
[output omitted]
Dell#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is 10.11.131.254 to network 0.0.0.0
Destination
-----------
*S 0.0.0.0/0
C 10.11.130.0/23
Dell#

VLAN Interfaces

VLANs are logical interfaces and are, by default, in Layer 2 mode. Physical interfaces and port channels can be members of VLANs.
For more information about VLANs and Layer 2, see
NOTE: To monitor VLAN interfaces, use Management Information Base for Network Management of TCP/IP-based
internets: MIB-II (RFC 1213).
Gateway
-------
via 10.11.131.254, Te 1/1
Direct, Te 1/1
Layer 2
Dist/Metric Last Change
----------- -----------
1/0 1d2h
0/0 1d2h
and Virtual LANs (VLANs).
375
Interfaces