Dell S4048–ON Configuration Manual page 830

S-series 10gbe switches

Hide thumbs Also See for S4048–ON:

Table of Contents

Dell#02:39:18: %STKUNIT4-M:CP %SYS-5-CONFIG_I: Configured from console

Reload each unit in the stack. After the reload is complete, the four units come up as a stack with unit 1 as the management unit,

unit 2 as the standby unit, and the remaining units as stack-members. All units in the stack can be accessed from the management

To view the stack unit information after the reload, use the show system brief command.

Dell#show system brief

Stack MAC : 00:01:e8:8c:53:32

Reload Type : normal-reload [Next boot : normal-reload]

-- Stack Info --

Unit UnitType

---------------------------------------------------------------

-- Power Supplies --

Unit Bay Status Type

--------------------------------------

-- Fan Status --

Unit Bay TrayStatus Fan0 Speed Fan1 Speed

-----------------------------------------

Speed in RPM

The following example shows how to configure two new switches for stacking using 10G ports.

Dell-1(conf)#stack-unit 0 stack-group 0

Setting ports Te 1/1 Te 1/2 Te 1/3 as stack group will make their interface configs

obsolete after

[confirm yes/no]:yes

Dell-2(conf)#stack-unit 0 stack-group 0

Setting ports Te 1/1 Te 1/2 Te 1/3 as stack group will make their interface configs

obsolete after

[confirm yes/no]:yes

Dell-1#show system stack-ports

Topology: Ring

Interface Connection Link

------------------------------------------------------------------

CurTyp Version

Status Status Group

4810-8-3-12-1447 64

Troubleshooting