Assigning An Ip Address To A Port Channel - Dell S4048–ON Configuration Manual

untagged port-channel id number
An interface without tagging enabled can belong to only one VLAN.
• Remove the port channel with tagging enabled from the VLAN.
INTERFACE VLAN mode
no tagged port-channel id number
or
no untagged port-channel id number
• Identify which port channels are members of VLANs.
EXEC Privilege mode
show vlan
Configuring VLAN Tags for Member Interfaces
To configure and verify VLAN tags for individual members of a port channel, perform the following:
1. Configure VLAN membership on individual ports
INTERFACE mode
Dell(conf-if)#vlan tagged 2,3-4
2. Use the switchport command in INTERFACE mode to enable Layer 2 data transmissions through an individual interface
INTERFACE mode
Dell(conf-if)#switchport
3. Verify the manually configured VLAN membership (show interfaces switchport interface command).
EXEC mode
Dell(conf)# interface tengigabitethernet 1/1
Dell(conf-if-te-1/1)#switchport
Dell(conf-if-te-1/1)# vlan tagged 2-5,100,4010
Dell#show interfaces switchport te 1/1
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
Name: TenGigabitEthernet 1/1
802.1QTagged: True
Vlan membership:
Q Vlans
T 2-5,100,4010
Dell#

Assigning an IP Address to a Port Channel

You can assign an IP address to a port channel and use port channels in Layer 3 routing protocols.
To assign an IP address, use the following command.
• Configure an IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
– ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in slash format (/24).
382
Interfaces