Important Points To Remember; Stacking Installation Tasks; Create An Stack - Dell S4048–ON Configuration Manual

cd
clear
copy
delete
dir
disable
enable
exit
format
fsck
pwd
rename
reset
show
ssh-peer-stack-unit
start
telnet-peer-stack-unit
terminal
upload
Dell(standby)#
-----------------CONSOLE ACCESS ON A MEMBER----------------------------
Stack(stack-member-0)#?
reset-self Reset this unit alone
show Show running system information
You can connect two units with two or more stacking cables in case of a stacking port or cable failure. Removal of only one of the
cables does not trigger a reset.

Important Points to Remember

• You can stack up to six systems.
• You cannot stack one system with other system types.
• You cannot enable stacking and virtual link trunking (VLT) simultaneously on the device. To convert a stacked unit to VLT, refer to
Reconfiguring Stacked Switches as
•
• All the ports in a stack-group are placed in stacking mode. Unused ports in that group cannot be used as data ports.
• Stacking on the device is accomplished through front-end user ports on the chassis.
• All stack units must have the same version of Dell Networking OS.

Stacking Installation Tasks

The following are the stacking installation tasks.
• Create a Stack
• Add Units to an Existing Stack
• Split a Stack

Create an Stack

Stacking is enabled on the device using the front end ports.
No configuration is allowed on front end ports used for stacking. Stacking can be made between 10G ports of two units or 40G ports
of two units. The stack links between the two units are grouped into a single LAG.
826
Stacking
Change current directory
Reset functions
Copy from one file to another
Delete a file
List files on a filesystem
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Format a filesystem
Filesystem check utility
Display current working directory
Rename a file
Reset selected card
Show running system information
Open a SSH connection to the peer stack-unit
Start shell
Open a telnet connection to the peer stack-unit
Set terminal line parameters
Upload file
VLT.