Accessing The System Remotely; Configuring The Management Port Ip Address - Dell Networking Z9500 Getting Started Manual

Figure 13. Port Numbering

Accessing the System Remotely

You can configure the system to access it remotely by Telnet.
The system has a dedicated management port and a management routing table that is separate from the
IP routing table.
1. Configure an IP address for the management port (refer to
Address).
2. Configure a management route with a default gateway (refer to
3. Configure a username and password (refer to

Configuring the Management Port IP Address

To access the system remotely, assign IP addresses to the management ports.
NOTE: Assign different IP addresses to each stack-unit's management port.
1. Enter INTERFACE mode for the Management port.
CONFIGURATION mode
interface ManagementEthernet slot/port
– slot range: 0
– port range: 0
2. Assign an IP address to the interface.
INTERFACE mode
ip address ip-address/mask
– ip-address: an address in dotted-decimal format (A.B.C.D).
– mask: a subnet mask in /prefix-length format (/ xx).
3. Enable the interface.
INTERFACE mode
no shutdown
Getting Started Guide
Configuring the Management Port IP
Configuring a Management
Configuring a Username and
Route).
Password).
29