No Ip Address - Dell S4048–ON Configuration Manual
S-series 10gbe switches
Hide thumbs
Also See for S4048–ON:
- Configuration manual (1146 pages) ,
- Deployment manual (78 pages) ,
- Troubleshooting manual (29 pages)
Table of Contents
Advertisement
no ip address
3.
Place the interface in Layer 2 mode.
INTERFACE PORT-CHANNEL mode
switchport
4.
Add one or more port interfaces to the port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
interface: specify one of the following interface types:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
5.
Ensure that the port channel is active.
INTERFACE PORT-CHANNEL mode
no shutdown
6.
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to an attached device.
INTERFACE PORT-CHANNEL mode
vlt-peer-lag port-channel id-number
The valid port-channel ID numbers are from 1 to 128.
7.
Repeat Steps 1 to 6 on the VLT peer switch to configure the same port channel as part of the VLT domain.
8.
On an attached switch or server: To connect to the VLT domain and add port channels to it, configure a port channel. For an
example of how to verify the port-channel configuration, refer to
To configure the VLAN where a VLT peer forwards received packets over the VLTi from an adjacent VLT peer that is down, use the
peer-down-vlan parameter. When a VLT peer with BMP reboots, untagged DHCP discover packets are sent to the peer over the
VLTi. Using this configuration ensures the DHCP discover packets are forwarded to the VLAN that has the DHCP server.
Configuring a VLT VLAN Peer-Down (Optional)
To configure a VLT VLAN peer-down, use the following commands.
1.
Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
2.
Enter the port-channel number that acts as the interconnect trunk.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
The range is from 1 to 128.
3.
Enter the VLAN ID number of the VLAN where the VLT forwards packets received on the VLTi from an adjacent peer that is
down.
VLT DOMAIN CONFIGURATION mode
peer-down-vlan vlan interface number
The range is from 1 to 4094.
VLT Sample
Configuration.
Virtual Link Trunking (VLT)
917
Advertisement
Table of Contents
Troubleshooting
