Dell S4048–ON Configuration Manual page 714

redistribute isis [level-1 | level-1-2 | level-2] [metric metric-value] [route-map map-
name]
– metric-value: the range is from 0 to 16.
– map-name: the name of a configured route map.
• Include specific OSPF routes in RIP.
ROUTER RIP mode
redistribute ospf process-id [match external {1 | 2} | match internal] [metric value]
[route-map map-name]
Configure the following parameters:
– process-id: the range is from 1 to 65535.
– metric: the range is from 0 to 16.
– map-name: the name of a configured route map.
To view the current RIP configuration, use the show running-config command in EXEC mode or the show config
command in ROUTER RIP mode.
Setting the Send and Receive Version
To change the RIP version globally or on an interface in Dell Networking OS, use the following command.
To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive only one or the other
version, use the ip rip send version or the ip rip receive version commands in INTERFACE mode.
You can set one RIP version globally on the system using system. This command sets the RIP version for RIP traffic on the
interfaces participating in RIP unless the interface was specifically configured for a specific RIP version.
• Set the RIP version sent and received on the system.
ROUTER RIP mode
version {1 | 2}
• Set the RIP versions received on that interface.
INTERFACE mode
ip rip receive version [1] [2]
• Set the RIP versions sent out on that interface.
INTERFACE mode
ip rip send version [1] [2]
Examples of the RIP Process
To see whether the version command is configured, use the show config command in ROUTER RIP mode.
The following example shows the RIP configuration after the ROUTER RIP mode version command is set to RIPv2. When you
set the ROUTER RIP mode version command, the interface (TenGigabitEthernet 1/1) participating in the RIP process
is also set to send and receive RIPv2 (shown in bold).
To view the routing protocols configuration, use the show ip protocols command in EXEC mode.
Dell#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 23
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
714
Routing Information Protocol (RIP)