Access Control Lists - Cisco Catalyst 3750-E Software Configuration Manual

Unsupported Commands in
Cisco IOS Release 12.2(53)SE2
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the Catalyst 3750-E or 3560-E switch prompt but are not supported in this release,
either because they are not tested or because of Catalyst 3750-E or 3560-E switch hardware limitations.
This is not a complete list. The unsupported commands are listed by software feature and command
mode.

Access Control Lists

Unsupported Privileged EXEC Commands
access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].
show access-lists rate-limit [destination]
show accounting
show ip accounting [checkpoint] [output-packets | access violations]
show ip cache [prefix-mask] [type number]
Unsupported Global Configuration Commands
access-list rate-limit acl-index {precedence | mask prec-mask}
access-list dynamic extended
Unsupported Route-Map Configuration Commands
match ip address prefix-list prefix-list-name [prefix-list-name...]
OL-9775-08
A P P E N D I X
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
3
3-1