Software Update; Firmware Update - Arkel ARCODE Quick Installation Manual

Arkel Elektrik Elektronik San. ve Tic. A.Ş.

SOFTWARE UPDATE

When AREM is first connected to the CANBus line, if AREM's SD card doesn't have the software found in ARCODE,
AREM will inform that an update is needed. Start the update pressing the button F1. The system will be restarted when
the update is complete. All ARCODE peripherals are updatable. For this reason, with each peripheral added to the
elevator, the software needs to be updated.
Figure-1a: firmware update
***Peripherals: They are all units that run on CANBus line. Each unit has a unique address. During update, other
peripherals are searched and updated after ARCODE is updated.
CAR PANEL COTROLLER (CPC): It is the board for car call. It is used to make a call for the car.(socket type)
CAR PANEL CONTROLLER (CPC-T): The car call buttons are connected to this board wire by wire.(terminal type).
More than 16 stops, this is not possible to use CPC-T board.
INSPECTION BOX CONTROLLER (IBC): It is revision box's card. The communication between control panel and
car is made by this board.
ENCODER ABSOLUTE (ENCA): It is the card for encoder link for gearless machines.
ENCODER INCREMENTAL (ENCI): It is the card for encoder link for geared machines.
IO-0210: This board gives extra 2 prog.inputs and 10 prog.transistor outputs to the user.
ARKEL

Choose "firmware update" icon and press
"Enter".

The latest update is the one having the nearest
date. Start software update by pressing
"Enter".

While carrying out setup, if there are
peripherals not connected to the CANBus
line, you will have to update the software
again. Otherwise, peripherals you connected
later won't work.
55
www.arkel.com.tr
Appendix-1
ARCODE