Dip Switch Settings Of Cpc-T Board; Io-0210 Board - Arkel ARCODE Quick Installation Manual

Arkel Elektrik Elektronik San. ve Tic. A.Ş.

2-DIP SWITCH SETTINGS OF CPC-T BOARD

CPC-T board can work up to 16 stops.
Dipswitch-1
ON Door-A enable
OFF Door-A disable
CPC-T board can be optionally used instead of CPC board. As seen in the table above, the dip-switch settings are
different from each other. So, please pay attention this case while doing dip-switch settings.
For CPC-T board, car call button connections are done wire by wire with terminal. If the system has more than 16
stops, it is not possible to use CPC-T board.

IO-0210 BOARD

In some cases, programmable inputs and outputs may not be enough. Then, this IO-0210 board would be useful. This
board gives 2 inputs and 10 transistor outputs to the user.
There are 8 dip-switches. The logic of these dip-switches is as follows:
For outputs, 1 and 2 dipswitches are used to select the group number of output:
From "Programmable outputs" parameter, the outputs should be assigned from related group number. (Tools  device
parameters  programmable outputs  IO-0210 board outputs)
1 pc. IO-0210 board gives 10 programmable transistor outputs to the user.
For inputs, other 6 dipswitches (from 3(MSB) to 8(LSB)) works with a binary logic. For example;
MSB: Most Significant Bit (3rd dip-switch)
LSB: Least Significant Bit (8th dip-switch)
You can program 64 different IO-0210 boards for inputs.
000000 "IO-0210-1 board PI1 and IO-0210-1 board PI2"
000001 "IO-0210-2 board PI1 and IO-0210-2 board PI2"
000010 "IO-0210-3 board PI1 and IO-0210-3 board PI2"
000011 "IO-0210-4 board PI1 and IO-0210-4 board PI2"
000100 "IO-0210-5 board PI1 and IO-0210-5 board PI2" and so on...
This can be chosen from 0 up to 63. (64 pcs.)
ARKEL
Dipswitch-2
Door-B enable
Door-B disable
1 2 Prog.output
OFF OFF 1st group
OFF ON 2nd group
ON OFF 3rd group
ON ON 4th group
57
www.arkel.com.tr
Dipswitch-3 Dipswitch-4
Gray outputs Outputs are inverted
Binary outputs Outputs are normal
Appendix-1
ARCODE