Bridging Of Safety Chain; Bridging Of Top And Bottom Limit Switches; Bridging Of Car Top Inspection Signal; Step-3: Preparations For Auto-Tune - Arkel ARCODE Quick Installation Manual

Arkel Elektrik Elektronik San. ve Tic. A.Ş.

Step-3: Preparations for Auto-tune

Auto-tune process must be performed by ARCODE before initial set-up of an elevator. In this way ARCODE
learns characteristic of motor. During the Auto-tune the elevator must be operated manually, therefore the
recall command has to be provided. For recall operation make the following connections

Connect the mains power of the control panel (L1, L2, L3, N, PE)

Bridge the safety circuit by the terminals in control panel shown below.
Control Panel Terminals

Bridge the signals of top and bottom limit switches (817 and 818) to terminal 100 on KBK-10&11 connection
board shown below.
KBK-10&11

Bridge the car top inspection signal (869) to terminal 100 on KBK-10&11 connection board shown below.
KBK-10&11
 KBK10&11 connection board is used for all required connections for shaft. That board includes supply and
inputs of all safety chain, car CANBus input/output, and car connections. If you prefer pre-wired connections, all
connector connections are sign with labels on flex cables.
ARKEL
Figure-6: bridging of safety chain
Figure-7a: bridging of top and bottom limit switches
Figure-7b: bridging of car top inspection signal
Figure-8a: KBK10&11 connection board
42
www.arkel.com.tr
ARCODE