Installation Of Magnets For Sml1-Sml2 Door Zone Sensors - Arkel ARCODE Quick Installation Manual

Arkel Elektrik Elektronik San. ve Tic. A.Ş.
 Make the installation of bar magnets for SML1&SML2 door zone switches. The cables of magnetic switches must be
connected ML1-ML0-1000 and ML2-ML0-1000 terminals on IBC board respectively.
CAR
FLOOR LEVEL
Figure-14: Installation of magnets for SML1-SML2 door zone sensors

If motor has brake mikroswitch(es) connect it to BRM and BRM2 inputs.(see figure 4-2). And select "on"
"Mechanical brake monitoring" and "Mechanical brake-2 monitoring".

Also "Operation mode" must be selected "Normal Operation" which is located under "Basic settings".
ARKEL

Move the car to the end of floors.

Car threshold must be exactly at the floor level.

15cm Install the bar magnet opposite to the zone magnetic switches. The middle of
the ribbon magnet must be on a level with the middle of the magnetic
switches.
15cm

The distance between magnetic switches and magnet must be 1-2 cm.

30 cm bar magnets must be fixed with screw or glue.

Repeat this installing operation at all floors.
48
www.arkel.com.tr
ARCODE