Meaning Of 7-Segment Messages On Arcode - Arkel ARCODE Quick Installation Manual

Arkel Elektrik Elektronik San. ve Tic. A.Ş.
Switch number 4 is used for indicator outputs. If switch number 4 is 1, it gives inverted gray output. If it is 0, it gives
output as gray. The switch number 5 is free for future features. The dip switch number 6 must be "0". If it is "1", it will
work in test mode. "ON" on the bottom switch means "1".

MEANING OF 7-SEGMENT MESSAGES ON ARCODE

INIT:
UpEn:
O-in:
notu:
noSh:
120-:
Fire:
RcLL:
inSP:
tune:
SHFL:
ErXX:
rtrX:
L. X:
L X:
1.58:
-0.35:
door:
EUAC:
ARKEL
Elevator goes bottom floor for reset(Initialising)
Enca board is being updated (Updating Enca)
Only inspection
Needed autotuning(No Tuning)
Needed Shaft learning (No Shaft Learning)
No 120 signal
Fire mode
Recall mode
Inspection mode
Autotune is being done
Shaft learning is being done
There is an error that XX code. (If it is flashing this means elevator is blocked)
Elevator go out an error and it will retry X seconds later (x:1-5)
Elevator is waiting at X. floor door zone
Elevator is waiting at X.floor but the car isn't at door zone.
Elevator is going with speed of 1.58 m/s
Elevator is going downward with speed of 0.35m/s
There is a call but the door is open
Rescue mode
60
www.arkel.com.tr
Appendix-2
ARCODE