Download Print this page
   

Advertisement

Loading Roll Paper
Loading Roll Paper
Before using the printer, make sure it's set up as described
in Chapter 1 of the Printer Guide.
Setting Up the Paper and Spindle
1
Open the roll paper cover and lift out the spindle.
2
Slide the movable paper stop off the left end of the
spindle.
3
Position the roll so the paper unwinds as
shown, then slide the roll onto the spindle so it
fits securely against the paper stop.
Handle the roll carefully and avoid
touching the printable side of the paper
with bare hands. Fingerprints may affect
print quality.
paper stop
4
Slide the movable paper stop back onto the spindle
and insert it firmly into the end of the roll.
5
Insert the white end of the spindle (with the fixed
paper stop) into the right mounting bracket.
6
Place the black end of the spindle into the left
mounting bracket.
1
Continue

Advertisement

   Also See for Epson Stylus Pro 10600 Archival Ink

   Related Manuals for Epson Stylus Pro 10600 Archival Ink

   Summary of Contents for Epson Stylus Pro 10600 Archival Ink

  • Page 1

    Loading Roll Paper Loading Roll Paper Before using the printer, make sure it’s set up as described in Chapter 1 of the Printer Guide. Setting Up the Paper and Spindle Open the roll paper cover and lift out the spindle.

  • Page 2: Loading Roll Paper For Printing

    Loading Roll Paper for Printing Once the roll paper is attached to the spindle and inserted in the printer, you’re ready to load it for printing. Make sure the printer is turned on. Then press the button repeatedly until one of the...

  • Page 3: Printing On Posterboard

    Sheet Make sure the paper set lever is all the way in, in the secured position. To avoid damaging the printer, never move the paper set lever while the Operate or Pause light is flashing. Feed the sheet into the paper slot until it meets resistance.

  • Page 4

    First print a nozzle check pattern, as described below. If dots are missing or out of place in the pattern, then run a cleaning cycle. Load a sheet of paper (or roll paper) in the printer. Press the button repeatedly until SelecType ™...

  • Page 5

    Item PAPER THICK=STD on the display. If you are using EPSON paper, leave this setting If you are using other media, enter the thickness value of the paper in 0.1-mm increments by pressing the button. Check the media specifications for –...

  • Page 6: Checking Ink Levels

    * Your printer uses one black ink cartridge (Matte Black or Photo Black). To switch black ink types, you have to follow a special procedure (see your Printer Guide), so be sure to replace the black cartridge with the same type as you are currently using.

  • Page 7

    Hold the cartridge so the arrow mark is on the left side and points to the rear of the printer. Then insert the cartridge into the slot. Don’t force it. If you can’t insert the cartridge smoothly, you may have the wrong cartridge.

  • Page 8: Status Messages

    Press the Pause button to continue. Printer is warming up, performing maintenance, or charging ink. Printer is paused. To resume printing, press the Pause button. Printer is paused to let ink dry. Wait for the number of minutes shown. Explanation Response Ink cartridge(s) nearly Replace ink cartridge(s) indicated empty (printing continues).

  • Page 9: Where To Get Help

    World Wide Web Support for non-EPSON RIP EPSON and EPSON Stylus are registered trademarks of SEIKO EPSON CORPORATION. EPSON UltraChrome, EPSON Archival, and EPSON Photographic Dye are trademarks and EPSON Preferred is a service mark of Epson America, Inc. Copyright © 2002 by Epson America, Inc.

This manual also for:

10600

Comments to this Manuals

Symbols: 0
Latest comments: