Epson ActionLaser 1600 Service Manual page 3

F C C C o m p l i a n c e
For American Users
This equipment has been tested and found to comply with limits for a Class B digital device
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio or television reception. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to
radio or television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from the one connected to the receiver
For Canadian Users
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus as set out in the radio interference regulations of the Canadian Department of
Communications.
Le présent appareil numérique n'èmet pas de bruits radioélectrique dépassant les limites applicable
aux appareils numériques de Classe B prescribes clans le règlement sur le brouillage radioélectriques
édicté par le Ministère des Communications du Canada.
C a u t i o n
The connection of a non-shielded equipment interface cable to this equipment will invalidate the
FCC Certification of this device and may cause interference levels which exceed the limits
established by the FCC for this equipment. It is the responsibility of the user to obtain and use a
shielded equipment interface cable with this device. If this equipment has more than one interface
connector, do not leave the cables connected to unused interfaces.
Changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
ii
S t a t e m e n t
EPSON ActionLaser 1600 Service Manual