Replace All Covers - 3D Systems ProJet 4500 Installation Manual

3DPrint/3D Sprint
Install the 3DPrint software.
or
Install the 3D Spring software. Please refer to the 3D Sprint Installation Guide for the latest computer requirements found in the Soft-
ware Downloads tab in the 3D Systems Infocenter.
Notes to Installer
• The customer MUST have administrator privileges on the computer the where software will be installed on AND the
computer must meet or exceed the specifications stated in the ProJet® 4500 User Guide.
• Disable all power saving settings. (Some computers ship with a 30-minute time-out on the disc drives. This will stop a print job after
30 minutes.)
3DPrintEdit Pro
Install 3DEdit Pro.
Note to Installer
Make sure you complete the registration process to acivate this copy of 3DEdit Pro. Refer to the installation paperwork that was shipped
with the printer, or consult the 3DEdit Pro online User Manual.
17

REPLACE ALL COVERS

Before setting up 3D Printer for customer build, replace all the covers to the machine.
3D Systems, Inc.
41