3D Systems ProJet 4500 Installation Manual page 20

6. This alert message indicates what the current network configuration
is set to (installs of new machines will always default to DHCP).
Press CONTINUE.
7. This alert message explains the process of changing the current
configuration type.
Press CONTINUE.
8. REBOOT NOW? is displayed.
TO USE DHCP CONFIGURATION:
Select NO - The printer will now automatically be assigned an address.
You can now skip to step 9 of these instructions.
TO USE STATIC IP CONFIGURATION:
Select YES and then a screen appears informing you to immediately
press and hold the Control Knob as the printer reboots.
This process allows you to manuallyenter an IP address.
Perform the following steps: "A" through "E" on the next page.
3D Systems, Inc.
20