4. Squeeze the handle until grease dispenses from the tip. Wipe clean
with a clean paper towel.
5. Snap the grease gun onto the Slow Axis fitting. Squeeze the trigger
2 - 3 times or until you feel the tension change and then STOP. Do
not over-grease.
6. Slide the Fast Axis forward and back several times to distribute the
grease evenly.
6. Replace the plastic cover.
NOTE: DO NOT lubricate the Fast Axis during installation. It was fully lubricated at the factory. ONLY add oil when 3DPrint
prompts you to as part of routine maintenance. Too much oil will damage the printer.
3D Systems, Inc.
38