Symbol Definitions; Descriptions; Prerequisites; Equipment - 3D Systems ProJet 4500 Installation Manual

1

SYMBOL DEFINITIONS

The following symbols are used on the 3D printer and in this manual.
General Caution: User should take care to avoid possible damage to equipment.
Hot Surface: User should use care when working near or on the labeled item.
High Voltage: User should use appropriate electrical safety precautions.
2
DESCRIPTION
This procedure describes how to install a 3D Printer at a customer site. This procedure is intended to be performed by an installer trained
to install a 3D Systems ProJet
3

PREREQUISITES

• Installer/trainer must have been trained by 3DSystems in proper installation methods and practices.
• 3D Printer must be at the customer's facility.
• Customer must have all necessary site prep completed. This includes any power, network, partitions or other work.
• The customer must designate a computer that will be used for 3DPrint
• It is suggested the customer set up a specific work area for using the 3DPrint
would include a table or two, the computer workstation, and shelves for supplies and printed parts.
4
EQUIPMENT / PARTS REQUIRED
• 3D Printer and its accompanying Starter Kit and Accessories Kit.
• Recommended Dealer Tools (See 3DS Central for List).
• Heavy Duty wire cutters (to remove metal straps).
• 9/16" Hex socket (to remove the fasteners on the pallet).
• Scissors (to remove shrink wrap).
• Phillips screwdriver (to remove panels).
3D Systems, Inc.
4500 3D Printer.
®
software and control the 3D Printer.
®
software and control the 3D Printer - typically this
®
3