Assemble The Grease Gun - 3D Systems ProJet 4500 Installation Manual

12

ASSEMBLE the GREASE GUN

1. Unscrew the bottom cap of the
and plunger.
2. Remove the plastic cap
grease with a cotton swab.
3. Liberally apply grease to the sides of the
the plunger and spring and tighten the bottom cap.
4. Unscrew the tube of the grease gun from the handle. If there is
already a grease cartridge
ing the grease cartridge) perform steps 5, 6, and 7 before beginning
this step.
3D Systems, Inc.
grease gun and remove the spring
from the grease cartridge and scoop some
rubber plunger. Reinstall
in the gun (if you are replacing or reseat-
33