Configuring Re-Dhcp Portal Authentication - HP FlexFabric 5700 Series Security Configuration Manual

Hide thumbs Also See for FlexFabric 5700 Series:
Table of Contents

Advertisement

Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
A user can perform portal authentication by using the HP iNode client or through Web page. Before
passing
the
http://192.168.0.1 1 1:8080/portal and all Web requests will be redirected to the authentication page.
After passing the authentication, the user can access Internet resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[Switch] display portal user interface vlan-interface 100
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
Authorization ACL: --
VPN instance: --
MAC
0015-e9a6-7cfe

Configuring re-DHCP portal authentication

Network requirements
As shown in
an IP address through the DHCP server. A portal server acts as both a portal authentication server and
a portal Web server. A RADIUS server acts as the authentication/accounting server.
Configure re-DHCP portal authentication. Before passing the authentication, the host is assigned a
private IP address. After passing the authentication, the host gets a public IP address and can access
Internet resources.
Server name
--
authentication,
IP
2.2.2.2
Figure
51, the host is directly connected to the switch (the access device). The host obtains
Mask
the
user
can
access
VLAN
Interface
100
Vlan-interface100
145
Action
--
Prefix length
Prefix length
only
the
authentication
page

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents