dummyhead
dummyhead
GOVERNOR SYSTEM
GOVERNOR ARM/CONTROL BASE REMOVAL/INSTALLATION
GOVERNOR SYSTEM
Remove the fuel tank (base manual 82Z4100: page 5-3).
After installation, adjust the no load engine speed (page 6-3).
GOVERNOR ROD/ANTI-SURGE SPRING
REMOVAL/INSTALLATION:
Remove the governor arm to a point where
the groove [1] of the throttle arm lines up
with the governor rod [2], and then lift the
governor rod out of the hole of the throttle
arm and unhook the anti-surge spring [3].
[2]
[1]
BOLT (6 x 12 mm) (2)
CONTROL BASE
SPRING
ADJUSTING SCREW
6-2
[3]
GOVERNOR ARM BOLT
NUT (6 mm)
GOVERNOR ARM
INSTALLATION:
SK type:
Hook the governor spring to the hole marked "1".
Tighten the governor arm nut to more than 3.0
N·m (0.3 kgf·m, 2.2 lbf·ft), and then make sure
that the clearance is more than 0.5 mm (0.02 in).
More than 0.5 mm (0.02 in)
SK type
(60 Hz)
NUT (6 mm)