Initial System Configuration; Initial Ip Configuration - Polycom MGC-50 Getting Started Manual

Initial System Configuration

Initial IP
Configuration
Installing the
MGC Manager
Starting the MGC
Manager
Defining an MCU
Connecting
to an MCU
Configuring the
Network Services
The MGC-50/MGC-100 requires basic configuration before you can start
running conferences.

Initial IP Configuration

The system is shipped with a default IP address: 129.254.4.8. Ordinarily,
you need to change the MCU's default IP address to the IP address
appropriate for the site's LAN. This section describes how to modify it using
a monitor and terminal to connect directly to the MCU.
To modify the MCU default IP address to the site's IP address:
1. Remove the Main Control Module cover.
MUSIC
LINE IN
Figure 3-1: MGC-100 Rear Panel
NET
A
B
COM COM 1 ALARMS
LAN
10/100 Mbits
3
KB0
3-1