Polycom MGC-50 Getting Started Manual page 46

MGC-50/MGC-100 Getting Started Guide
3-22
2. Right-click the unit (span) to configure and select one of the clocking
options:
Table 3-6: Net-2/Net-4/Net-8 Unit Clocking Options
Option
Set as Primary
Clock Source
Cancel Primary
Clock Source
Set As Backup
Clock Source
Cancel Backup
Clock Source
3. After setting the clock source, a Warning message box opens, instructing
you to reset the MCU.
The configuration changes take effect only after the next MCU reset or
start up and they are shown in the Configured Clock column in the Status
pane.
Description
Sets this unit as the primary clock source.
Stops this unit from acting as the primary clock
source.
Sets this unit as the backup clock source.
Stops this unit from acting as the backup clock
source.