Polycom MGC-50 Getting Started Manual page 140

MGC-50/MGC-100 Getting Started Guide
8-10
Table 8-2: MCU's Cards Status Columns
Field
Clock
Configured Clock
Status
Occupied Units
Faulty Units
Disabled Units
Num Units
For more information about viewing card parameters, see MGC Manager
Administrator's Guide, Chapter 4.
Description
This column is valid only for ISDN and Serial (MPI-8)
Network Interface cards.
On the Net-2/Net-4/Net-8 Network Interface Module,
the Master and the Backup clocks can be set on any
of the spans connected to the module.
This column indicates which Network card/span is
used as the Master Clock and which one is used as
the Backup clock.
Indicates which ISDN Network card or MPI Span
was configured as the Primary network interface (for
clocking), and which one is used as backup.
Changes take effect and are updated during the next
MCU reset or power up.
Indicates the card status; Normal or Faulty.
Indicates the units on the card that are currently
used to run conferences. For example, 1, 6 indicates
that two units, unit # 1 and unit # 6 are used to run
conferences.
Indicates if there are units on the card which are
faulty and the sequential number of the faulty unit.
Indicates the units that were disabled by the
operator.
Indicates the total number of units available for each
module.