Nortel 2350 Installation And Basic Configuration Manual page 65

• System IP address: 10.10.10.4, on IP interface 10.10.10.4 255.255.255.0
Note.
system IP address, and converts the input into an IP interface with a subnet mask,
and a system IP address that uses that interface. Likewise, if you configure this
information manually instead of using the quickstart command, you must
configure the interface and system IP address separately.
• Default route: 10.10.10.1
• Administrative user mxadmin, with password letmein. The only management access the switch allows by default is
CLI access through the serial connection.
• System Time and date parameters:
●
Date: 15th of November, 2004
●
Time: 6:58 PM
●
Timezone: PST (Pacific Standard Time), with an offset of -8 hours from Universal Coordinated Time
(UTC)
• Unencrypted SSID name: public
• Username user1 and password pass1 for WebAAA; username user2 and password pass2 for WebAAA
• Encrypted SSID name: corporate
• Username alice and password alicepass for 802.1X authentication; username bob and password bobpass for
802.1X authentication
• Directly connected AP access points on port 2 and 3, each model 2330 (applies only to WSS models 2360 and
2370)
The IP addresses, usernames, and passwords in this document are examples. Use values that are appropriate for your
organization.
If you configure time and date parameters, you will be required to enter a name for the timezone, and then enter the value
of the timezone (the offset from UTC) separately. You can use a string of up to 32 alphabetic characters as the timezone
name.
Figure 19 shows an example. Users bob and alan can access encrypted SSID corporate on either of the AP access points.
Users user1 and user2 can use the same APs to access unencrypted SSID public. Although the same hardware supports
both SSIDs and sets of users, AAA ensures that only the users who are authorized to access an SSID can access that
SSID. Users of separate SSIDs can even be in the same VLAN, as they are in this example.
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
The quickstart script asks for an IP address and subnet mask for the
WSS Setup Methods 65