Nortel 2350 Installation And Basic Configuration Manual page 151

auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
14 Create radio profile branch1_radprof, map service profile branch1_srvcprof to it, and assign the AP
radios to the radio profile. Then verify the changes.
2370# set radio-profile branch1_radprof
success: change accepted.
2370# set radio-profile branch1_radprof service-profile branch1_srvcprof
success: change accepted.
2370# set ap 2 radio 1 radio-profile branch1_radprof
success: change accepted.
2370# set ap 2 radio 2 radio-profile branch1_radprof
success: change accepted.
2370# set dap 1 radio 1 radio-profile branch1_radprof
success: change accepted.
2370# set dap 1 radio 2 radio-profile branch1_radprof
success: change accepted.
2370# show radio-profile branch1_radprof
Beacon Interval:
1
Max Tx Lifetime:
2000
RTS Threshold:
2346
Short Retry Limit:
5
Long Preamble:
NO
Tune Channel:
no
Tune Channel Interval:
600
Power Backoff Timer:
300
Countermeasures:
yes
WMM enabled:
Service profiles: branch1_srvcprof
15 Enable the radios and verify the changes:
2370# set radio-profile branch1_radprof mode enable
success: change accepted.
2370# show ap config
Port 2: AP model: 2330, POE: enable, bias: high, name: MP02
boot-download-enable: YES
load balancing group: none
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Configuring a 2350 Switch for a Branch Office 151
100 DTIM Interval:
2000 Max Rx Lifetime:
2346 Frag Threshold:
5 Long Retry Limit:
NO Allow 802.11g clients only:
yes Tune Power:
3600 Tune Power Interval:
10 Channel Holddown:
none Active-Scan:
yes