Nortel 2350 Installation And Basic Configuration Manual page 112

112 Configuring a 2370, 2360, or 2380 Switch for Basic Service
Table 10.Defaults for Radio Profile Parameters (continued)
Parameter
long-retry
max-rx-lifetime
max-tx-lifetime
preamble-length
rts-threshold
service-profile
short-retry
wmm
Configuring Radio-Specific Parameters
The following parameters are specific to individual radios and are not controlled by a radio profile:
• Channel number
• Transmit power (in decibels referred to 1 milliwatt)
• External antenna model (if applicable)
These parameters have the following defaults:
• Channel number:
●
The default channel number for 802.11b/g is 6.
●
The default channel number for 802.11a is the lowest valid channel number for the country of
operation.
• Transmit power—Highest setting allowed for the country of operation or highest setting supported on the hardware,
whichever is lower
320656-A
Radio Behavior When
Default
Parameter Set To Default
Value
Value
5 Sends a long unicast frame up to five
times without acknowledgment.
2000 Allows a received frame to stay in the
buffer for up to 2000 ms (2 seconds).
2000 Allows a frame that is scheduled for
transmission to stay in the buffer for up
to 2000 ms (2 seconds).
short Advertises support for short 802.11b
preambles, accepts either short or long
802.11b preambles, and generates
unicast frames with the preamble length
specified by the client.
Note: This parameter applies only to
802.11b/g radios.
2346 Transmits frames longer than 2346
bytes by means of the
Request-to-Send/Clear-to-Send
(RTS/CTS) method.
No service Default settings for all service profile
profiles defined parameters, including encryption
parameters, are used.
5 Sends a short unicast frame up to five
times without acknowledgment.
enable Prioritizes traffic based on the Wi-Fi
Multimedia (WMM) standard.